Skip to content
RACING INNOVATION FOR THE FUTURE
Country/region
0 Cart
Item added to your cart

Strange Dual Master Cylinder - 1.125" Bore Includes Dust Boot, Pushrod, & Fittings

$89.00
$89.00
Shipping calculated at checkout.

Description

Application:

Vehicles with front and rear manual disc brakes. Normally used with single or two piston calipers in front and four piston in the rear. This is assuming Drag Race brakes as factory calipers may require more fluid volume Brake pressure will be delivered equally out of both ports. Use of an adjustable proportioning valve is highly recommended.

Using All Wheel Disc brakes
Use 2 lb residual pressure valves if mounted at or below the level of the calipers

Using With Drum Brakes
Any line supplying drum brakes will require a 10 lb residual pressure valve

Recommendation
6.5 to 1 pedal ratio

Note
Port closest to the push-rod flows the most volume of fluid
This port needs to be plumbed to the brakes requiring more capacity

Assembly Includes

Aluminum Master Cylinder With Plastic Reservoir
– 1.125″ bore size
– Cast aluminum body anodized for corrosion resistance
– Flange for firewall mounting – 21/64″ holes on 3.187″ centers
– Provisions for side mounting – .390″ holes on 5 1/2″ centers
– 1/2″-20 brake line holes with brass inverted flare seats

Additional Components
– 3/8″-24 x 4.200″ long push-rod
– Push-rod locking grommet
– Dust boot to protect piston bore
– 1/2″-20 brass inverted flare adapters for 3/6″ brake line
– 3/16″ brake line nuts

Note
Silicone Brake Fluid Is Not Recommended

Part Number: B3359TA

Installation Instructions HERE

      Tab title

      Application:

      Vehicles with front and rear manual disc brakes. Normally used with single or two piston calipers in front and four piston in the rear. This is assuming Drag Race brakes as factory calipers may require more fluid volume Brake pressure will be delivered equally out of both ports. Use of an adjustable proportioning valve is highly recommended.

      Using All Wheel Disc brakes
      Use 2 lb residual pressure valves if mounted at or below the level of the calipers

      Using With Drum Brakes
      Any line supplying drum brakes will require a 10 lb residual pressure valve

      Recommendation
      6.5 to 1 pedal ratio

      Note
      Port closest to the push-rod flows the most volume of fluid
      This port needs to be plumbed to the brakes requiring more capacity

      Assembly Includes

      Aluminum Master Cylinder With Plastic Reservoir
      – 1.125″ bore size
      – Cast aluminum body anodized for corrosion resistance
      – Flange for firewall mounting – 21/64″ holes on 3.187″ centers
      – Provisions for side mounting – .390″ holes on 5 1/2″ centers
      – 1/2″-20 brake line holes with brass inverted flare seats

      Additional Components
      – 3/8″-24 x 4.200″ long push-rod
      – Push-rod locking grommet
      – Dust boot to protect piston bore
      – 1/2″-20 brass inverted flare adapters for 3/6″ brake line
      – 3/16″ brake line nuts

      Note
      Silicone Brake Fluid Is Not Recommended

      Part Number: B3359TA

      Installation Instructions HERE